Allow it to idle for 1 to 2 minutes.Ģ3. Clean the area around the engine oil dipstick.Ģ4. Remove the dipstick and check the oil level.
#POLARIS RANGER 570 TRANSMISSION OIL CHANGE FULL#
PS-4 Full Synthetic oil is part number 2876244 for 1 quart (946 mL) and part number 2876245 for 1 gallon (3.78 L).ġ9. Reinstall and tighten the dipstick and the oil fill cap, if applicable.Ģ0. Start the engine. The Extreme Duty Oil Change Kit is part number 2890056. The PS-4 Full Synthetic Oil Change Kit for a RANGER 570 Full-Size or RANGER CREW 570-6 is part number 2202166. Your Polaris Oil Change Kit comes with the correct amount of oil for your vehicle. Torque to 12 ft-lbs (16 Nm).ġ8. Add 2 quarts (1.9 liters) of the recommended oil. The sealing washer is part number 5812232.ġ7. Reinstall the drain plug.
#POLARIS RANGER 570 TRANSMISSION OIL CHANGE FREE#
The sealing surfaces on the drain plug and crankcase should be clean and free of burrs, nicks or scratches. The filter is part number 2540086.ġ6. Install a new sealing washer on the drain plug. Check to make sure the O-ring is in good condition.ġ5. Install the new filter and rotate it clockwise by hand until the filter gasket contacts the sealing surface and then turn it an additional ¾ of a turn. Make sure the old filter O-ring is completely removed.ġ4. Lubricate the O-ring on the new filter with a film of fresh engine oil. Do not allow hot oil to contact skin.ġ2. Turn the filter counter-clockwise with a 2.5-inch (64mm) oil filter wrench to remove it.ġ3. Using a clean dry cloth, clean the filter sealing surface on the crankcase. Caution: Hot oil can cause burns to skin. Tip: Place a rag in the bottom of the drain pan to prevent splashing of oil.ġ0. Remove the drain plug with a 6mm Allen socket. Allow it to warm up at idle for 2 to 3 minutes.ĩ. Place a drain pan beneath the engine crankcase. To change the oil and filter, do the following:ġ. Position the vehicle on a level surface in a well-ventilated area.ģ. Start the engine. Access the drain plug from the bottom of the vehicle. The crankcase drain plug is located on the bottom of the crankcase. When changing the oil on your Polaris RANGER 570 Full-Size or RANGER CREW 570-6, always wear safety glasses and nitrile gloves. Always check and change the oil at the intervals outlined in the Periodic Maintenance Chart in your Owner's Manual. To learn more about tools, read the Tools and Fasteners Guide.
0 kommentar(er)
